FLUODE Gas Sampling Bag
FLUODE film has the same characteristics as PVDF (Polyvinylidene
fluoride). It is
an alternative of PVDF film with low cost.
Fluode film has the same same characteristics as PVDF
(Polyvinylidene fluoride). It is an alternative of PVDF film with
low cost.Our FLUODE gas sampling bags are equipped with renovated,
patented valves. Valve materials are polycarbonate . Unlike other
popular valves, our valve does not have O-ring inside to prevent
leakage so contamination is minimized.
*superb strength and low permeability
*excellent chemical inertness and stability
Standard FLUODE Gas Sampling Bag
Sizes:0.5L,1L,2L,3L,4L,5L,8L,10L,15L,20L,30L,and 40L or customized
Side-opening stopcock valve Side-opening PTFE valve plus PTFE
fitting PTFE straight valve plus fitting
It is made of polytetrafluoroethylene (PTFE). The patented design
utilizes mouldeling, self-sealing mechanism, no O-ring is inside
therefore cross-contamination is eliminated. The PTFE valve can
handle gases that there is not corrosive to PTFE. The valve can be
used in VOCs analysis.
Operating instructions for FLOUDE bag
1.Avoid filling pressure higher than 6000Pa. Fill gas until the bag
is fully expanded, however, it is not so tense when you press it
using your finger.
2.Keep away from flame and high temperature when filling and
storage. Avoid contacting sharp stuff.
3.Before use, flush sampling bags three times with the gas you want
4.When using a needle to draw gas from highly elastic septum,
squeeze the septum with fingers in order to restore the sealing
property after pulling out the needle.
5.Heat-resisitance temperatures should be 150°C to 170°C .