Our 3D printer membrane is our newest products for 3D printer
releasing specially .It is used for 3D printers which (UV
curing,SLA and DLP type).It is placed in a tray for the glue to
release, instead of silicone film
1. high transmittance, UV light through rate of 92%, the curing
time is shorter, better curing effect, higher precision printing;
2. More durable, release more than thirty thousands times. (refer to the printed page);
3. For many types of UV light curing 3D printer.
Note: If you need any products of ours, please kindly contact with us
directly by following contaction . Then we can reply you faster and
easy . Thanks
Type A: Peel off the protective film ,and then paste the release film
onto the tank.Take the place of silicon film. More conveniently to
use than silicon film ,much longer working life than silicon film
,just like to pasted Mobile screen protective film .
Type B :without adhesive ,but it need to be fixed at the bottom of the
Size: 210 * 290 mm, and about the same size A4 paper, special sizes
(20 or more) contact the owner customization.
Thickness: Type A: Thickness 0.125 mm; Type B: Thickness 0.1 mm.
Note: There is a mark to mention its the
Type A has adhesive and has positive and negative side.After peeling off the protective film ,paste the release film
to the tank directly .The one without adhesive is protective film
,peel it off and away,use the one with adhesive (adhesive side face
to tank to paste)
Type B has no adhesive ,fixed the film by user ,its both sides can be used
HOW TO USE IT ?
Please choose a clean ,windless,dustfree room to operate. Washing
hands clean, using art knife to cut the film into the right size
you need .Edge must be orderly. Size can be a little smaller than
the glue tank’s bottom plane.
Clean the glue tank with microfiber cleaning cloth which is sent with the goods (or other glasses cloth),no Dust or blot,or it will comes our bubble
Tear up the protective film from the 3D printer film at one corner
and then paste it like pasting a phone’s protecting film .